IMPORTANT: Read safety rules and instructions carefully before operating equipment.MTD PRODUCTS INC P.O. BOX 368022 CLEVELAND, OHIO 44136-9722Rear Tin
10Figure 8• To transport tiller, lower the depth stake (use top adjustment hole).• To adjust the depth stake, remove the clevis pin and hairpin clip.
11• Remove the belt cover as described in the belt replacement section on page 12.• Remove the hairpin clip and spring washer from the idler pulley ro
12CLEANING THE TINE AREAClean the underside of the tine shield after each use. The dirt washes off the tines easier if washed off immediately instead
13SECTION 9: OFF-SEASON STORAGEIf the tiller will not be used for a period longer than 30 days, the following steps should be taken to prepare the ti
14SECTION 11: PARTS LIST FOR MODEL 458
15MODEL 458REF.NO. PART NO. DESCRIPTION1 611-0020 Wheel Shaft Ass’y: 33T2 611-0021 Tine Shaft Ass’y: 18T3 611-0128 Jack Shaft Ass’y4 611-0129 Input Sh
16MODEL 4582018823101606137622534276430392763263236333129662641303024283540264944505951655355565457584446424911166314719517260611215121238212267707068
17MODEL 458REF.NO. PART NO. DESCRIPTION1 747-1152 Shift Rod 2 649-0041 Upper Handle Ass’y3 649-0034 Lower Handle Ass’y4 710-3005 Hex Screw 3/8-16 x 1.
18MODEL 4581817241927464512269618251428202114442223165217131534043424139323331302910343736373835
19MODEL 458REF.NO. PART NO. DESCRIPTION1 686-0111 Belt Cover Brkt. Ass’y2 710-0237 Hex Bolt 5/16-24 x .62" Lg.3 710-0412 Hex Bolt 1/4-28 x .75&qu
2TABLE OF CONTENTSContent PageImportant Safe Operation Practices...3, 4Loose Parts ..
MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by MTDPRODUCTS INC (“MTD”) with respect to new merchandisepurchased
3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESWARNING: THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOTFOLLOWED, COULD ENDANGER THE
4• If situations occur which are not covered by this manual, use care and good judgment. Contact your dealer for assistance.CHILDREN• Tragic accidents
5SECTION 2: LOOSE PARTSHandleAssembly Depth StakeAssembly Control RodNOTE: Cable tie not shown.
6SECTION 3: ASSEMBLING YOUR TILLERIMPORTANT:The Engine is shipped WITHOUT GASOLINE or OIL. After assembly, see separate engine manual for proper fuel
7Figure 4ATTACHING THE CLUTCH CABLE Attach the clutch cable to the handle as follows (be careful not to kink the cable).• Remove threaded eyebolt and
8Now move the shift lever to FORWARD (Wheels Forward) position. Carefully engage the clutch by lifting the clutch control bail against the handle. The
9CLUTCH CONTROL BAILThe clutch control bail is located below the handle. See Figure 7. Lifting the clutch control bail against the handle engages the
Kommentare zu diesen Handbüchern